Yamato Scientific IJ300W Low Temperature Incubator - Manual (Page 16)

12
Description and Function of Each Part
Characters of the Controller
The characters VS4 controller shows are as follows:
Character Identifier Name Purpose
FiX
Fixed Temperature
Setting Mode
Used for starting the fixed temperature
operation.
Sv Temperature Setting Used for setting the temperature.
AStP
Timer Setting Mode
Display
Represents the setting of quick auto stop or
auto stop operation.
AStr
Timer Setting Mode
Display
Represents the setting of auto start
operation.
tim Time Setting
Used for setting the time.
PrG3 Program Type
Used for choosing program type from 1 to 3.
(Refer to Page 23 " Program Operation".)
PAt Program Pattern
Used for choosing program pattern. (Refer to
Page 23 " Program Operation".)
End Time Up
Displays when the timer operation is
completed or while inputting number of
program steps. (Refer to Page 23 " Program
Operation".)
Sv-1
Program Temperature
Setting
Used for setting the temperature for each
step in the program. (Sv-1 to Sv-30 is
shown.)
t-1 Program Time Setting
Used for setting the time for each step in the
program. (t-1 to t-30 is shown.)
PS-3
Step Number to be
Repeated
Used for choosing the step number to be
repeated under the program operation with
repeat function. (Refer to Page 27 " Use
program repeat function".)
Pc-2 Repeating Times
Used for setting the repeating times under
the program operation with repeat function.
(Refer to Page 27 " Use program repeat
function".)
cAL
Calibration Offset
Setting
Used for inputting the calibration offset
temperature. (Refer to Page 30 "Other
Function".)
oH
Overheating Prevention
Setting
Used for setting temperature for overheating
prevention device. (Refer to Page 16 "Setting
of Overheating Prevention Device ".)
LocK Key Lock
Locks the keys on control panel to protect
from unnecessary operation. (Refer to Page
30 "Other Function".)
* Also refer to Page 15 "Operation Mode, Function Setting Key, and Characters".