Yamato Scientific IJ300W Low Temperature Incubator - Manual (Page 12)

8
Before Using this unit
Change the Direction of Opening/Closing Door (only for IJ300/300W)
ƒ IJ300/300W can be changed the direction of opening/closing the door easily.
ƒ The door opened/closed to the right or left can be selected according to the place where it is
installed and the convenience of operation.
ƒ The direction of opening/closing the door is set to left at the shipping from factory. If the
door should be opened/closed to the right, the direction of opening/closing the door can be
changed by the following procedure:
1. Lay down the main body backward in a way that the door unit may come above.
2. By using Phillips screwdriver, remove the hinge mounting screws fixing the door in the lower
part of the main body.
3. Pull off the door downward carefully.
4. Pull off the guide pin fixing the upper part of the door, and insert it into the screw hole on the
opposite side (right side).
5. Turn the door 180 degrees, and insert it into the upper guide pin.
6. After adjusting the door position, fix the hinge in the lower part of the door.
7. Replace the main body to complete the procedure.
Low tem p incubator
IJ300
1. Lay down the main body.
4. Remove the guide pin, and
move it to the right side.
2. Remove the lower hinge
and move it to the right
side.
5. Turn around the door
3. Pull out the door.
6. Fix the lower hinge.