Yamato Scientific IJ100 Low Temperature Incubator - Manual (Page 8)

6
Before Using this unit
Requirements for Installation
CAUTION!
7. Before/after installing
•
It may cause injure to a person if this unit falls down or moves by the earthquake and the
impact. etc..To prevent, take measures that the unit cannot fall down, and not install to busy
place.
8. Handling of power code
•
Do not entangle the power cord. This will cause overheating and possibly a fire.
•
Do not bend or twist the power cord, or apply excessive tension to it. This may cause a fire
and electrical shock.
•
Do not lay the power cord under a desk or chair, and do not allow it to be pinched in order to
prevent it from being damaged and to avoid a fire or electrical shock.
•
Keep the power cord away from any heating equipment such as a room heater. The cord's
insulation may melt and cause a fire or electrical shock.
•
If the power cord becomes damaged (wiring exposed, breakage, etc.), immediately turn off the
power at the rear of this unit and shut off the main supply power. Then contact your nearest
dealer for replacement of the power cord. Leaving it may cause a fire or electrical shock.
•
Connect the power plug to the outlet which is supplied appropriate power and voltage.
9. Draining of condensation
•
When the cooling device is operated, condensation may occur on the cooling surface. The
condensation is led out via the drain provided at the bottom on the rear the unit. Therefore,
be sure to set the attached drain-receiving pan.
10. Setting shelf
•
Fix the two shelves (attached accessory) on the appropriate position.