Yamato Scientific IJ100 Low Temperature Incubator - Manual (Page 15)

13
Handling Precautions
WARNING!
If a problem occurs
If smoke or strange odor should come out of this unit for some reason, turn off the power key
right away, and then turn off the circuit breaker and the main power. Immediately contact a
service technician for inspection. If this procedure is not followed, fire or electrical shock may
result. Never perform repair work yourself, since it is dangerous and not recommended.
Substances that cannot be used
Never use explosive substances, flammable substances and substances that include explosive
or flammable ingredients in this unit. Explosion or fire may occur. (Refer to page24 “List of
Dangerous Substances”.)
When the setting temperature is 35°C or less
When the setting temperature is 35°C or less, pay attention to dryness of sample. The cooling
device of this unit is operated by peltier element. It is set to operate when the setting temperature
is 35°C or less. If container for sample is open, sample may dry.
Condensation drainage
The cooling device may have condensation
during operation. It is drained through the port
on the base to the plate. Check the plate
sometime to avoid overflow.
CAUTION!
Do not step on this unit
Do not step on this unit. It will cause injury if this unit fall down or break.
Do not put anything on this unit
Do not put anything on this unit. It will cause injury if fall.
During a thunder storm
During a thunderstorm, turn off the power key immediately, then turn off the circuit breaker and
the main power. If this procedure is not followed, fire or electrical shock may be caused.
When you open and close the door
When you open and close the door, be careful not to be hit your hands or face. It may cause
injury.