Yamato Scientific DN410I Inert Oven - Manual (Page 55)

5
Control Panel
(1) POWER key: Key to change over the controller from the standby mode to the
operation mode or from the operation mode to the standby mode.
(2) MODE key: Key to select a function from program input, edit, delete modes,
hour/time setting, change-over mode, and other functions.
(3) DISPLAY key: Key to change-over the display content of the sub display (10).
Display content is changed over to set temperature, remaining
time, hour, execution segment No.
(4) MENU key: Key to select the operation mode. Each mode of fixed
temperature, auto-start, auto-stop and program operation can be
selected.
(5) ENTER key: Key to determine the input value of set value (temperature, time,
hour, etc.), selection mode, execution segment No. etc.
(6)/(7) (UP/DOWN) key: Key to change set value (temperature, time, hour, etc.) and to
choose a selection from various parameters on the function menu.
(8) ESCAPE key: Key to cancel the latest entry and recover the status that was valid
prior to the making the latest selection.
(9) Main Display: It displays temperature measurements, set values (temperature,
time, hour, etc.), program information, error information, etc.
(10) Sub Display: It displays set temperature, remaining time, current hour and
execution segment No. etc.
(11) Operation monitor: It indicates an operation mode.
a) (11) STANDBY lamp: It flashes to indicate that the instrument is in the preoperational
standby mode.
b) (11) Temperature
pattern lamp:
It illuminates to indicate the heat treatment process pattern
executed by the controller with flashing light indicating the point
currently in execution.
c) (11) OVER lamp: It flashes to indicate the end of auto-stop or program operation.
d) (11) TROUBLE
indicator lamp:
It blinks when an error is detected and displays the corresponding
code for that particular problem.
①
②
③
④
⑤
⑥⑦
⑧ ⑩
⑨
⑪ ⑪ ⑪ b ⑪ c
⑪
⑪ e
⑪ f
⑫
⑬
⑭
⑮
⑯