Yamato Scientific BU300 Low Constant Temperature Water Bath - Manual (Page 12)

10
BU300
1. Turn the power supply switch on
„ The power supply turns on when the power
supply switch is moved up.
2. Set the setpoint (desired temperature)
of immersion temperature control
device
„ Please set the setpoint of immersion
temperature control device. The method of a
detailed operation is described in the
instruction manual. Please see the instruction
manual for more detailed information.
3. Push the "On " side of the refrigerator
switch
„ So long as the setpoint of immersion
temperature control device is equal to or less
than the room temperature +5
°
C, turn the
power of the refrigerator on. Even if the
temperature in the reservoir is high, the
refrigerator can operate.
4. When you stop the refrigerator
„ Push the "OFF" side of the refrigerator switch.
Then, the refrigerator stops. In this case,
power of immersion temperature controller is
still ON. Please turn off the immersion
temperature controller if you do not use it any
more.
Caution
„ Do not turn on and off the refrigerator in a short term (5 minuets or less). This causes the refrigerator to
break down.
„ When making the low temperature in the reservoir low in the high room temperature, the drop of water
might adhere to this machine. Please wipe the drop of water off with a soft cloth in every case.