WORX WU434.1 1500W 190mm Circular Saw 240V - Manual (Page 13)

13
so proceed with extreme caution.
Clearly mark the area to be cut. Set the depth of cut on the saw.
Position the saw over the marked area with the front edge of the
base plate resting on the work surface and cutting guide aligned
with marked line on workpiece. Ensure the blade is not touching
but is close to the work surface. The moving lower guard must be
rotated open by using lever. Switch the saw on and gently swing
the blade down into the material but maintain a pivoting force on
the front edge of the base. The moving lower guard can now be
released for normal action of the guard.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Environmental protection
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.