Wood’s Powr-Grip MRTA611LDC2 - Manual (Page 17)

Rev 0.0/4-14 15 MRTA6-DC2: #35072
Note: Standard vacuum pads can stain or deform load surfaces with light colors or soft coatings.
Test such surfaces for detrimental effects before using the lifter on them. Alternative rubber
compounds are available for these applications; contact Wood’s Powr-Grip or an authorized
dealer for more information.
O
PERATING
E
NVIRONMENT
The operator must determine whether the lifter is intended to be used in each work environment,
in accordance with the following restrictions:
Never use lifter in dangerous environments.
• This lifter is not intended for use in any environment that is inherently dangerous to the
operator or likely to compromise the lifter's ability to function. Environments containing
explosives, caustic chemicals and other dangerous substances must be avoided.
• The lifter's work environment is limited by the Operating Elevation and Operating
Temperatures indicated in SPECIFICATIONS.
• The lifter's work environment must be free of metal particles or any other contaminates that
could cause a vacuum pump failure. Such contaminates could result in a load release and
possible injury to the operator or others nearby.
Environmental contaminates could result in vacuum pump failure.
• Using the lifter in wet environments may require the operator to take special precautions:
Moisture on contact surfaces of the load or vacuum pads diminishes the lifter’s slip resistance,
thereby reducing the lifting capacity (see MAINTENANCE: V
ACUUM
P
AD
M
AINTENANCE
: Pad to Load
Friction Coefficient).
Moisture reduces slip resistance of vacuum pads.
The lifter is not designed to be water-tight. Submerging the lifter or using it in rain may
damage lifter components; these and similar conditions must be avoided.
D
ISPOSAL OF THE
L
IFTER
After the vacuum lifter has reached the end of its Service Life (see SPECIFICATIONS), dispose of
it in compliance with all local codes and relevant regulatory standards.
Note: This lifter is equipped with a battery, which may be subject to special disposal regulations.
10
However, allowable thickness normally increases as load weight decreases. If necessary, contact Wood’s Powr-Grip for help in
determining the maximum thickness permitted when handling any specific load.