WarmlyYours Lava LED - Manual (Page 4)

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
25. Place the included Velcro strip on the controller and place the controller at the back of the LAVA, ensuring
that the sensor (pictured) comes to rest within a half inch of the bottom edge of the unit. This allows the signal
to reach the controller, without the controller being visible from the front of the unit. Once the location is
chosen, pull the paper backing off of the Velcro to expose the adhesive backing. Press the Velcro firmly to the
controller and the controller firmly to the LAVA.
26. Place the included Velcro strip on the LED Power Supply Transformer and place the transformer at the back
of the LAVA. Once the location is chosen, pull the paper backing off of the Velcro to expose the adhesive back-
ing. Press the Velcro firmly to the transformer and the transformer firmly to the LAVA.
Attach the power lead from the transformer to the controller. With the help of an assistant, lift the Lava to plug
transformer into wall socket. Attach transformer to rear of the Lava. Attach Lava unit to wall. See Installation
Instructions for further information concerning mounting Lava to the wall.
INPUT
: DC 12V
O
U TPUT
: DC 12V
C
O NTROLL
E R
MODULE
AC/DC ADAPTER
INPUT: 120VAC
OUTPUT: 12 VDC 4A