WarmlyYours Lava Side Cover - Manual

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
KIT Contents: Two (2) rolls of Scotch TM brand Mounting Tape ½” x 75”
Four (4) Pieces of pre-cut, high-temperature polycarbonate
Step 1. Verify that the correct sizes and quantity of polycarbonate pieces have been received and inspect cosmetic condition of each piece.
Step 2. Test fit each cover to verify proper dimensions and fit. Take special note of clearance in areas around the pilot light and power switch.
Contact WarmlyYours if any dimensions are incorrect.
Step 3. Using a cotton ball or rag soaked in rubbing alcohol, clean all 4 sides of the lava as shown
Step 4. After the sides of the Lava have dried, attach the double-sided tape around the entire outer edge of the unit as shown.
More than one roll of tape may be needed to accomplish this. Do NOT peel the backing off of the tape yet.
Lava Side Cover
Installation Instructions