WarmlyYours Lava LED - Manual (Page 2)

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
7. Place the LED Controller next to bracket as shown. This will ensure proper placement of the controller sensor
and the starting location of the LED Strip. Locate beginning of LED strip at the middle of the bottom of the LAVA
unit so that the lighted portion is located within 2” of the bottom edge.
8. Secure the LED strip temporarily every 3”-4”with tape as it is being laid into the lower, right corner (looking at
unit from the rear). This first run will slightly decend from 2“ to 1” from the edge in the first corner. This will allow
for any necessary overlap at the end of the LED Strip.
10. Continue to place the LED strip within 1” along the right, outside edge, using the tape to temporarily hold it
in place.
11. Repeat the folding procedure as in the previous corner. Repeat this for the final 2 corners.
12. After making the turn in the lower left corner, it is time for the final measurement. As the strip comes out of
the bottom left corner, it will need to be marked for final cutting. PLEASE TAKE NOTE: If there is too great of a
gap between the END of the strip and the beginning of the strip, the reflected light in that area will not be the
same intensity as the rest of the unit. If installed in this manner, the LED brightness at the bottom of the
installed LAVA may appear dimmer than the other sides. It is better to have a little overlap in LED coverage than
it is to have a gap and the resulting lower level of brightness. The LED strip should terminate within an inch of
the bottom edge. Take note that excessive overlap of the LED sections will result in a brighter area visible in that
area. The “Beginning” of the strip will need to be located closer to the center of the unit if there is overlap, that
way the line cords will not block any light from reaching the wall. It is better to do this sizing before actually
cutting the strip and mounting it because once the LED strip has been cut, it is not returnable/refundable.
2”
9. As the strip approaches the first corner, bend the strip as shown to
form a 90-degree turn. Do not fold strip directly at an LED or at the area
where the “scissor” icon appears. The strip may need to be adjusted for
the best location of the fold.
IN PUT
: D C 12
V
O U TPUT
: D C 12V
C O N TR
O
LLER
M O D ULE
START POINT