WarmlyYours Lava LED - Manual

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
LAVA LED Kit (IP-LED-KIT-LV) Installation Instructions
TOOLS NEEDED: Marker, tape, tape measure, scissors
1. Remove contents from box.
2. Identify and verify kit contents as listed below.
3. Assemble the parts as shown. Test the system to see if it is functioning correctly. Operation instructions
come separately. If the unit does not function, please call WarmlyYours Technical Support department at
800-875-5285. If the system operates correctly, disconnect unit from power and disconnect all other connec-
tions and proceed to Step 4. Warning: Do not operate spooled LED’s for more than a couple of minutes during
testing. Spooled LED’s can overheat rapidly and damage may result.
Attach LED strip to the LAVA
4. Remove LED strip from spool.
5. Locate the “scissor” icon on the LED strip. This icon repeats at equal distances throughout the entire length of
the strip. This is where the strip can be cut to the correct length for the installation. Never cut the strip at any
other location, doing so will permanently damage the product and void the warranty. Do NOT cut the strip until
instructed!
6. Very carefully place the LAVA unit face down on a non-abrasive surface, like carpeting. All LED attachments
are done on the rear of the unit. Loosely attach mounting brackets to rear of LAVA to confirm clearances of LED’s
and electrical components.
INPUT: DC 12V
OUTPUT: DC 12V
CONTROLLER
MODULE AC/DC ADAPTER
INPUT: 120VAC
OUTPUT: 12 VDC 4A
INPUT
: DC 12V
OUTPUT
: DC 12V
CO
N
T R O LL
E R
MODULE
AC/DC ADAPTER
INPUT: 120VAC
OUTPUT: 12 VDC 4A
LED Spool LED Controller LED Remote LED Power supply (transformer & removable line cord)
Velcro Strips
Velcro
Strips When making this connection verify
that the arrows line up.