Vortex Optics RAZOR HD 1-4X24 (MOA) - EBR-556 MOA - Manual (Page 10)

10
8
Riflescope Mounting
To get the best performance from your Vortex Razor
riflescope, proper mounting is essential. Although not
difficult, the correct steps must be followed. If you are
unsure of your abilities, it would be best to use the services of a
qualified gunsmith.
Centering of the Reticle
The Vortex Razor HD riflescope is pre-set from the factory
with the reticle in the center of the adjustment ranges. If
you have changed the settings and wish to reset the reticle
to the center, this can be done easily:
1. Turn the dial (windage or elevation) fully in either
direction until stopped. Do not force the dial—as soon as any
resistance is felt, stop turning.
2. Carefully counting the dial rotations, turn the dial in the
other direction until stopped. Again, stop turning as soon as
resistance is felt.
3. Turn the dial back again half the amount of rotations
counted and that adjustment will be centered.
After this procedure is completed for both windage and
elevation dials, the reticle will be approximately centered.