Vigo VG06062 - Manual (Page 8)

FIG.4 SEAL STRIP INSTALLATION DIAGRAM
12
13
10
5
THIS SIDE MUST
LOOK INSIDE THE
CABIN
THIS SIDE MUST
LOOK INSIDE THE
CABIN
MAGNET
3/8"
[10mm]
5
4
10
15
13
4 14
8
MODEL VG06062
B. INSTALLING THE WATER SEAL STRIP TO HINGE PANEL
1. Clean the side glass panel (#4) edge where the door side seal strip (#14) is to be installed with rubbing
alcohol.
2. [SEE FIG.4]
3. Verify that the soft flange of the seal strip faces toward the inside of the shower cabin before seal strip
installation.
4. Install the seal strip according to the diagram. See Note: A. Leave the extra at the top of the seal strip
that is overlapping the glass and cut at finish of install.
4
14
NOTE: A
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
6
14
10
6
15
4
5
13
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
NOTES:
1. If the seal strip is not flat and is twisted, soak the strip in hot water and press the seal strip back into position.
2. Part #14 is reversible and pre-cut on top and bottom to fit in proper configuration. Cutting/finishing is needed
but only after fully installing and only at the top of the unit.
3. The door magnetic seal strip (#10) and the side seal strips (#6) will be 10mm shorter than the side glass panel.
This is to compensate for the depth of the bottom rail. The door magnetic seal strip (#10) is reversible and will
need to be cut at top for best aesthetic approach.
3/8"
[10mm]
10