Vigo VG06062 User Manual

Page 11

MODEL VG06062

VIEW FROM INSIDE

FIG.8

HEX SCREW

SIDE GLASS
PANEL (4)

DOOR (13)

THIN

GASKET

VIEW FROM THE TOP

HINGE (8)

OUTSIDE OF
THE CABIN

INSIDE OF

THE CABIN

PLATE

E. INSTALLING THE DOOR

Clean the door (#13) glass surfaces where the hinges (#8) are to be installed with rubbing
alcohol.

Place magnetic seal strip (#10) to the panel. The magnetic side should be facing the inside

and the clear side be facing the outside. Make sure the seal is level with the bottom of the

panel. Do not install the handle first, this is dangerous and may cause the glass to break.
Install the top hinge first for safety and ease of install.

Position the door onto the hinges. Hold securely in place using shims. The seal (#14) may get

stuck between the two panels of glass. Pull the seal out of the groove using your fingers and

nothing sharp, making sure not to damage the seal. Tighten allen key screws.

Install the hinges as illustrated (FIG.8) Use the hex key supplied.

Adjust hinge so the gaps are equal at top and bottom and pull door panel away from side

panel to allow the door to swing freely without crimping seal strip (#14).

Lift door panel to be level with hinge panel. Use PVC shims provided to hold firmly in place.

NOTE - You may need to add more than one shim per hinge as glass hole openings vary during

production. PVC shims prevent the door from sagging due to gravity and the
weight of the door. Never install without shims, this can cause the glass to break causing
property damage and bodily harm.

WARNING

DOOR PANEL INSTALLATION REQUIRES TWO OR MORE PEOPLE TO ASSIST

THIN

GASKETS

THIN
GASKET

SEAL STRIP (14)