Vigo VG06042A - Manual (Page 7)

7
MODEL VG06042
B. INSTALLING THE TURNING HINGE BASE
C. INSTALLING THE DOOR PANEL
1. Insert the convex portion of the turning hinge mirrored (#4) into the concave point of the turning
hinge base mirrored (#2) [SEE FIG. 4].
2. One installer manually inserts the convex portion of the turning hinge (#3) into the concave
portion of the turning hinge base (#1) and holds the position, while the other installer lifts the door
panel (#6) and gently slides it into both turning hinges at the same time.
3. Stop the sliding of the door panel at the proper location based on the pre-determined
configuration or the specific site space requirements.
4. Tighten three screws (supplied) on both turning hinges from inside the shower, respectively,
making sure the door panel is tightly secured by these two hinges and level.
FIG.3
5
2
15
16
1
5
FIG.4
6
1
3
2
4
1. Unscrew the plate on the turning hinge base mirrored (#2) and mount the turning hinge base
mirrored into the lower corner of the front fixed panel (#5).
2. Mark a hole on the floor for the mounting screw for the turning hinge base mirrored.
3. Remove the turning hinge base mirrored and drill a hole into the floor on the marked location.
Insert plastic anchor (#16) into the hole.
4. Mount the turning hinge base mirrored again, carefully cover the plate and tighten the screw
(supplied) from inside the shower [SEE FIG. 3].
5. Screw the turning hinge base mirrored into the floor with 1 1/8 " Phillips screw (#15). Make sure the
glass panel is perpendicular to the wall.
6. Remove the screw that connects the structural arm on the floor mount portion of part (#2).
Removing this is to prevent personal injury, silicone the void to prevent water entry. [SEE FIG. 3A]
7. Mount the turning hinge base (#1) to the upper corner of the front fixed panel, cover the plate and
tighten the screw (supplied) from inside the shower.
2
FIG.3A