Vigo VG06042A - Manual (Page 5)

Fiberglass or acrylic construction might not be sufficiently strong enough to support the shower
door enclosure. You should use the wood framing from behind the face edge of the stall to provide
a secure mounting to the door. Apply a bead of silicone between the walls and base of the stall.
For optimum performance, you should install the shower door perfectly level on a level surface. By
not leveling the unit during construction the unit may leak causing possible water damage.
IMPORTANT
!
Compare items on your invoice with what you have received. Carefully review the Packing List on page 2. If
any items are missing, please call Vigo Industries at 1-866-591-7792.
BEFORE STARTING
INSTALLATION OF THE SHOWER DOORS BY AN INEXPERIENCED PERSON MAY RESULT IN GLASS
BREAKAGE AND CONSEQUENTLY, CAUSE PERSONAL INJURY OR DEATH.
!
INSTALLATION INSTRUCTION
Installer is responsible for determining attachment method. Anchors are provided as one means of installation.
REQUIRED TOOLS:
- Square and/or Phillips #1 and #2 screwdriver
- Flat head screwdriver
- Electric drill; 1/8", 3/16" or 7/32" drill bit (According to wall)
- Level
- Measuring tape
- Non permanent pencil (HB)
- Clear silicone caulking
- Utility knife; Hacksaw
WARNING
- Handle fragile items with care to prevent personal injury or material damage.
- Glass on panels and doors in tempered and must never be cut to prevent personal injury.
WE STRONGLY RECOMMEND THAT A LICENSED PROFESSIONAL INSTALL THIS STANDING SHOWER
CABIN AND INCLUDE THE ASSISTANCE OF A SECOND PERSON TO INSTALL THE DOOR UNIT.
WARNING
MODEL VG06042
5
PREPARATION STEPS TO FOLLOW BEFORE INSTALLATION
1. Remove the plastic layer from the base border (if needed). Do NOT remove the plastic layer off
the plastic platform of the base.
2. Properly apply silicone to the wall and base joints.
IMPORTANT
To prevent damage to the finish, you should protect the shower cabin bottom with a cardboard
protector before beginning the installation.
Ensure that there is sufficient structural support behind the shower wall to hold the weight of the
shower door. If there is insufficient support, then reinforce the shower walls with wooden studs
prior to shower door installation. [SEE FIG.1]
IMPORTANT:
THE CLEAR GLASS MODEL HAS A REVERSIBLE DOOR AND CAN BE INSTALLED TO THE RIGHT
(CONFIGURATION "A") OR LEFT SIDE (CONFIGURATION "B"). (SEE CONFIGURATION DIAGRAMS ON PAGE 4)