Vigo VG0601 - Manual (Page 9)

9
VIEW FROM INSIDE
FIG.8
VIEW FROM THE TOP
MODEL VG06011
F. INSTALLING THE DOOR PANEL
WARNING !
DOOR PANEL INSTALLATION REQUIRES TWO OR MORE PEOPLE TO ASSIST
1. Clean all glass surfaces where the hinges (#8) are to be installed with rubbing alcohol.
2. Position the door onto the hinges
3. Place thin gasket on each of the doors, between the glass and the hinge. Continue to hold door
in position. [SEE FIG.8]
4. Install the hinges as illustrated (FIG.8) using the allen key (supplied with the hinges).
5. See step 3 under installation of the hinges.
6. Repeat Steps 1 through 5 for the other hinges.
G. INSTALLING THE SIDE & FRONT PANEL SUPPORT
1. Install the glass support assembly (#3) to the panel approximately two-thirds from the wall.
2. Tighten screws with the supplied hex key.
3. Install the wall connector (#1) and the structural arm (#2) to the support assembly (#3).
4. Mark holes on the wall for mounting screws.
5. Move the support assembly aside. Drill holes into the wall and place the plastic anchors (#19) into
the holes.
6. Move support assembly back into place. Screw into wall with 1-1/8" screws (#16).
7. Tighten all screws. [SEE FIG.9]
8. Repeat Steps 1 through 7 for the other support assembly.
HEX SCREW
FRONT
GLASS PANEL (5)
DOOR (13)
HINGE (8)
OUTSIDE OF
THE CABIN
INSIDE OF
THE CABIN
PLATE
THIN
GASKET
THIN
GASKET