View from inside – Vigo VG0601 User Manual
Page 7
D.
INSTALLING THE HINGE
1. Clean the glass surface where the hinges (#8) are to be installed with rubbing alcohol.
2. Screw the glass hinge (#8) to the front panel (#5) with a washer on each side of the panel as
shown. Use hex key. [SEE FIG.6]
3. Six small rubber gaskets are provided with the two hinges, these gaskets are spacers to fit
between the top or bottom portion of the hinge and the glass. This will provide a tight fit and will
not allow the door any movement in the fully installed position. Note that only four will be needed
but six are provided.
FIG.6
THIN GASKETS
VIEW FROM INSIDE
DOOR (#13)
C.
INSTALLING THE HANDLE
Assemble the door handles (#12) to the door (#13). [SEE FIG.5]
DOOR PANEL
OUTSIDE HANDLE
INSIDE HANDLE
SCREW
METAL WASHER
CLEAR WASHER
WHITE TUBE
GLASS SUPPORT
7
FIG.5
FRONT
GLASS PANEL (#5)
GLASS SUPPORT (7)
GASKET
SIDE GLASS PANEL
HEX SCREW
VIEW FROM THE TOP
WALL
FIG.4
HEX SCREW (17)
MODEL VG06011
METAL WASHER
THREADED SCREW