Vicor PI2003-EVAL1 Active ORing Evaluation Board - Manual (Page 4)

Initial Test Set Up
Baseline Test Procedure (Refer to Figure 3)
1.0 Recommended Equipment
1.1 Two Isolated DC power supplies - 0 – 60 V; 10 A
1.1.1 If the DC power supply outputs are not isolated,
two 10 A 100 V Schottky diodes are required,
as shown in Figure 4.
1.2 DC electronic load - 10 A minimum.
1.3 Digital Multimeter
1.4 Oscilloscope.
1.5 Appropriately sized interconnect cables.
1.6 Safety glasses.
1.7 PI2003 Product Data sheet.
Figure 3 – Layout configuration for a typical redundant power application, using isolated power supplies.
Figure 4 – Layout configuration for a typical redundant power application, using non-isolated power supplies.
Picor Corporation • www.picorpower.com PI2003-EVAL1 User Guide Rev 1.0 Page 4 of 8