Pi2002 – Vicor PI2002-EVAL1 Active ORing With Load Disconnect Evaluation Board User Manual
Page 5
Before initial power-up follow these steps to configure the
evaluation board for specific end application requirements:
2.0 Undervoltage (UV) and Overvoltage (OV) resistors set up:
2.1 UV and OV programmable resistors are configured
for a 3.3 V Vin (BUS voltage) application in a
two-resistor voltage divider configuration as shown in
Figure 4. UV is set to 2.6 V and OV is set for 3.8 V,
R1
OV
and R1
UV
are 2.00 K
Ω 1%. If PI2002-EVAL1 is
required to be used in a different Vin voltage
application please follow the following steps to
change the resistor values.
2.1.1 It is important to consider the maximum current
that will flow in the resistor divider and
maximum error due to UV and OV input .
current.
R1
UV
=
V(UV
TH
)
I
RUV
2.1.2 Set R1
UV
and R1
OV
value based on system
allowable minimum current and 1% error;
I
RUV
≥ 100 µA
R2
UV
= R1
UV
(
V(UV)
–1
)
V(UV
TH
)
Where:
V(UV
TH
) : UV threshold voltage
V(UV) : UV voltage set (0.5 V typ)
I
RUV
: R1
UV
current
R2
OV
= R1
OV
(
V(OV)
–1
)
V(OV
TH
)
Where:
V(OV
TH
) : OV threshold voltage
V(OV) : OV voltage set (0.5 V typ)
I
ROV
: R1
OV
current
PI2002
UV
OV
FT
FT
V_Logic
GND
R2
UV
R1
UV
R2
OV
R1
OV
Vin
Figure 4 – UV & OV two-resistor divider configuration
Ref. Desg.
U1
U2
R1
UV
R3
R14
R2
UV
R1
R12
R1
OV
R4
R15
R2
OV
R2
R13
Picor Corporation • www.picorpower.com
PI2002-EVAL1 User Guide Rev 1.0 Page 5 of 11
2.1.3 Example for 2.0 V Vin (BUS voltage), to set UV and OV for ±10% Vin set UV at 1.8 V and OV at 2.2 V.
R2
UV
= R1
UV
(
V(UV)
–1
)
= 2.00 K
Ω*
(
1.8 V
–1
)
= 5.20 K
Ω (or 5.23 KΩ % standard value)
V(UV
TH
)
0.5 V
R2
OV
= R1
OV
(
V(OV)
–1
)
= 2.00 K
Ω*
(
2.2 V
–1
)
= 6.80 K
Ω (or 6.81 KΩ % standard value)
V(OV
TH
)
0.5 V