UVP DigiDoc-It Imaging System - Manual (Page 6)

DigiDoc-It Imaging System 5
Connect the Camera to the Computer
NOTE: It is recommended to only connect the camera to the computer while the camera is off.
1. Connect the USB cable from the camera to the computer.
2. Turn the camera on and select A-DEP on the camera dial.
NOTE: Do not use the Doc-ItLS software while the camera dial is set to movie mode as doing
so may result in an error.
Set camera to A-DEP
Connect to Doc-ItLS Software
1. Open the Doc-ItLS software. The software should automatically identify the camera. The camera
control window should be active and ready to capture images.