UVP MegaCam 800 Camera - Manual (Page 4)

MegaCam 800 Camera 4
Once the software is installed, connect the camera USB (9) cable to the camera and then into an available port
on the computer.
Place the camera cover (10) on the top of BioSpectrum so that it covers the camera.
Install the VisionWorksLS software to run the
camera if not already installed. Refer to the PDF
VisionWorksLS software manual on the Support
CD or use the Help Files embedded in the
software for more information.
To connect the motorized lens (showing the
motorized fixed lens in the photograph):
Connect the Power Cable to the Power
Supply
Connect the Power Cable to an electrical
outlet
Connect the USB cable to an available port
on the computer.
Install the Camera drivers
Open VisionWorks software.
Connect the camera to a USB port on the computer with the USB cable provided and power connect the power
supply to the camera and an appropriate power outlet.
When the camera is first connected to the computer the “Found New Hardware” wizard will open. Select “Install
from a list or specified location (Advanced)” and click the “Next” button.
Select “Don’t Search. I will choose the driver to install.” The click the “Next” button.
Click the “Have Disk…” button and browse to the “C:\Windows\system32\drivers” folder. Open the drivers folder
and select “sisousb.inf” for the 800 camera select Open, Ok, Next, Finish.
Note: the installation may cause a warning message saying that the drivers are “not verified by Microsoft”. Select
“Continue Anyway” and the drivers will be installed correctly.
Note: to verify that the driver has been loaded go to Start > Programs > UVP > Sensovation Device Manager. A new
SVDeviceManager window opens. Ensure that the Sensovation HR830 camera appears. Select Save & Exit.
Accessories and Replacement Parts
To order accessories or replacement parts, contact UVP’s offices listed under Technical Support.
UVP Lens Controller
(pictured without
camera and lens)
Power Cable
Control Box
Power Supply
USB cable