UVP HM-4000 Multidizer - Manual (Page 13)

Hybridization Ovens
Page 13
Care and Cleaning
NOTE: Always unplug the unit from the electrical supply before cleaning or drying the unit.
The units are built to provide you with trouble-free operation. To ensure correct operation:
•
Wipe ANY water from inside and outside the unit with a soft cloth or sponge.
•
Use soap and water with a soft cloth or sponge to clean the unit.
•
Do not allow chemicals to remain on the unit’s surfaces.
•
Never clean the unit with abrasive pads or cleaners.
•
Never clean the unit with acetone or chloroform.
•
Clean the UV sensor regularly with a soft cloth and alcohol.
Bottle Care
Hybridization bottles are made of lead-free borosilicate glass which provides superior long-term reliability. Each
bottle includes a polypropylene cap and PTFE seal.
•
It is important to check your bottles regularly for chips, stress fractures and cracks. If these occur, the
bottle must be discarded.
•
Ensure bottles are stored either in a suitable rack or with caps replaced in between experiments. This
will protect the bottle and sealing area.
•
Replace “O” rings/PTFE seals when worn or leaky; replace “O” rings or seals every six months.
•
Wear protective gloves to protect your hands in the event of an accidental breakage.
•
Never over tighten caps on bottles as this will harm the seals. Hand tightening is sufficient.
•
If the cap is difficult to unscrew, never attempt to force the bottle cap open. Allow the bottle to cool and
retry. If the cap remains stuck, discard the bottle.
•
The bottles should not be used at temperatures above 70°C.