Unisteer 8010920-01 Late 1967-70 Mustang Rack Kit - Manual (Page 11)

Page 11 655650
6. Install the brass bearing collar from the old steering shaft onto the new steering shaft and
slide the new shaft through the column tube and wiggle through the bearing hole. Then
install the steering wheel and finger tighten the nut only.
7. From under the hood you can now install the provided brass washer and shaft u-joint to the
splined end. Once the brass washer and u-joint are in place and tight, finish securing the
steering wheel. This will seat the tapered piece in your column and you should have minimal
movement up and down on the steering wheel.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/16/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.