Unisteer 8010730-01 MOPAR B Body Kit - Manual (Page 7)

pg. 7 655530
2) The banjo fittings are pre-installed on the rack. DO NOT LOOSEN OR TIGHTEN THEM! Next,
install the braided stainless lines. The longer line goes from the AN fitting on the pump to the
pressure port of the rack. The shorter line goes from the side of the reservoir to the return port on
the rack.
DO NOT REVERSE THE LINES! THIS WILL BLOW THE SEALS
OUT OF THE RACK AND VOID YOUR WARRANTY.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/13/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.