Unisteer 8011940-01 Mercury Cougar Power Rack 1967-70 - Manual (Page 9)

Page 9 656790
14. When your lines are connected and the top bolt on the pressure port is torque to 20 ft. lbs. You may
top off the fluid in the reservoir and start the car.
15. Let the car idle and turn the wheels back and fourth slowly to remove air from the system.
16. Shut the car off and make sure you have no leaks and the level is full.
17. When your install is complete it will be necessary to have an alignment done.
Alignment Instructions
Toe In: 0 - 0.125
Camber: O.E. Specs
Caster: O.E. Specs
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 11/18/2011
Last Revised 6/26/2014
Copyright © 2011 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.