Unisteer 8011940-01 Mercury Cougar Power Rack 1967-70 - Manual (Page 12)

Page 12 656790
6. Install the brass bearing collar from the old steering shaft onto the new steering shaft and slide the
new shaft through the column tube and wiggle through the bearing hole. Then install the steering
wheel and finger tighten the nut only.
7. From under the hood you can now install the provided brass washer and shaft u-joint to the splined
end. Once the brass washer and u-joint are in place and tight, finish securing the steering wheel.
This will seat the tapered piece in your column and you should have minimal movement up and down
on the steering wheel.
If you have any questions or problems regarding this product please contact:
UNISTEER®
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Created on 11/18/2011
Last Revised 6/26/2014
Copyright © 2011 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means, electronic
or mechanical, including photocopying, recording or by any information storage and retrieval
system, without permission in writing from Maval Manufacturing Corporation.