Unisteer 8011940-01 Mercury Cougar Power Rack 1967-70 User Manual
Page 14
Page 14
656790
8. Once you have cut the inside piece off remove it from the column by sliding it off the end you cut the
rag joint off of.
9. Next take a brass or a drift and tap the inner tube into the steering column tube.
Note: This piece is collapsible. Tap it in about 1
” This will allow the clearance needed to install the
bearing.
10. Once that is complete you need to make sure the steering shaft itself is clean and free of burs. Install
the supplied bearing over the steering shaft and tap it into the column tube by walking it in with a
small hammer.
11. When that step is done you now need to measure down 1-
3/4” from the flat surface of the bearing to
the end of the steering shaft and mark it. Cut the steering shaft off at that mark.
12. You now need to install the provided aluminum bushing over the shaft.