TruXedo GM with Tracks 2007-2009 - Manual (Page 2)

P/N 1117152 Rev C
by truXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877- 878-9336 • Fax: (605) 664-9304 www.truxedo.com
2007 GM W/tracks Deuce InstaLLatIOn InstructIOns (cOntInueD)
Install Underbody Rails: Fold back hinged portion
of side rails, and stand inside pickup bed to install
underbody rails. Two plastic shims and two clamps
will be used for each underbody rail.
Fold Back
Underbody Rails
3
Tighten clamps securely on side
rails before driving vehicle.
WARNING
Install Side Rails: With tailgate closed, align side rails
flush with pickup bed rails and level with each other.
Lightly compress D-seal against tailgate. Clamp
side rails to bed rails, see step one for correct clamp
locations. Tighten securely.
1
High Bed Caps -
Adjust side rail height as needed to get a good
seal at front and back of cover.
These instructions replace step 1 thru 7 in the Deuce owners manual.
!
2
Tailgate
4
The underbody rails are marked driver and
passenger side. The rails will have weather seal
extending out the front of the rail. Place that
end toward the front bulkhead.
The seal can be trimmed to fit if needed.
Install Underbody Rails: Position underbody rails
flush with Truxedo Deuce side rails as shown. Clamp
underbody rails to the truck rails. Plastic shims will
need to be used in this step.
Place shim and clamp at or beyond
11.50” from the bulkhead.
Install Front Striker: Temporarliy remove plastic corner
cover. Install striker fastener (1117153) in the front cargo rail.
Assemble the striker bracket (1117150) toward the center of
the truck box.
5
Temporarily
remove cover
P.N. 1117150 Replace plastic cover
after assembly.
Continue with step 8 in the main Deuce manual.
Weather Seal
Pickup side
Rail.
Align this end
flush with main
rail.
Underbody Rail
Align weather seal arc
slightly higher than
the trucks rail.
Striker
fastener P.N. 1117153
See step 4 for correct plastic shim
location
Plastic Shim