TruXedo TruXport - Manual (Page 4)

D
secure loop to hook
fasteners on one side
rail by pressing edge of
cover along full length
of rail.
E
pull cover tight across
width of pickup bed.
secure loop and hook
fasteners on opposite
side rail.
A
release safety straps,
and unroll cover over
pickup bed. open tailgate.
Close cover:
Open cover:
___ 4___
12
14
D
always secure cover at front
of pickup bed with both safety
straps when cover is open.
saFety
straps
• To prevent accidental release of tailgate header, ensure header is securely latched to side rails on both sides of pickup bed
before driving vehicle.
• To prevent wind lift, secure loop and hook fasteners along entire length of both side rails before driving vehicle.
C
!
B
with tailgate open,
hook tailgate header
into header stops on
both sides of vehicle.
Cover tension:
there is no need to adjust cover length tension. the latch assembly is set to the correct tension.
Any modification done to this will VOID warranty.
For ease of operation, periodically clean with
high pressure water to remove dirt and dust.
9
13
C
rotate tailgate header
down until both latches
engage. listen for
double click.
latch assembly
with tailgate open, press downward
on first latch to release.
to release second latch, repeat
process on opposite side. Place
free hand on tailgate header to
control header movement on
release.
roll up cover. Do Not disengage
loop and hook fasteners prior to
rolling up cover.
A B
P/N 1116032 Rev Y
TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, South Dakota 57078
Call Toll Free: 1-877-TRUXEDO (1-877-878-9336) Fax: (605) 664-9304
Visit Us Online: http://www.truxedo.com
First latch
second latch
tailgate
Header
Keeping cover taut:
Periodically or as needed, pull cover tight across width of
pickup bed, secure loop and hook on side rails.
cover may appear loose or relaxed in cooler or cold conditions.
cover may appear tight in warmer or hot conditions.
tailgate
Header
Header
stop
latch
engaged
tailgate
Header
Use both hands to close!!!
space wide
Latch not fully engaged!!!
Latch fully engaged!!!
Both latches must be fully engaged!!!