TruXedo Edge - Manual (Page 4)

TENSION CONTROL
FRONT HEADER
ADJUST
HERE
EP 10: Set tension during warmest part of day. With cover closed, release hook and loop fasteners from both side
rails near cab. Roll cover opened and rotate tension controls to adjust. Close cover and recheck. Repeat until
satisfactory tension is achieved.
HEADER
COVER
TOGGLE
HEADER SEAL
HEADER STOP
SIDE RAIL
FRONT
HEADER
TENSION
CONTROL
● Cover tension must be adjusted manually.
● C heck cover tension after installation, seasonally, and after
extreme temperature changes.
● For best performance, adjust tension regularly to protect your
cover against wind wear.
LOCK TOGGLE INTO HEADER
HEADER WILL NOT LATCH:
• Check side rails to make sure they are level (Step 2).
• Make sure the header seal is not caught between the side rail and the header.
• Check position of side rails on pickup box - they may be positioned too low (Step 1).
FABRIC COVER IS TOO TIGHT OR TOO LOOSE: Adjust tension (Step 10).
TROUBLE SHOOTING
EP 6: Unroll cover toward tailgate and rest bows on
side rails. Rotate header into header stops and
press down to lock toggle into header. Cover
must be closed before closing the tailgate.
N OTE: Adjust tension
in small increments.
Slight adjustments yield
LATCHING & UNLATCHING COVER
COVER TENSION ADJUSTMENT
Questions?
Call our friendly customer service staff
at TruXedo Toll Free:
1-877-878-9336
Mon - Fri 8 am - 5 pm CST
OTE: If tailgate
has a key lock,
Edge ® Tonneau
Cover is secured
until tailgate is
unlocked and
opened.
PULL COVER OVER RAILS
TOGGLE
PRESS EDGES
STEP 8: To release cover, Trigger pull rear release toggle. Start
rolling cover toward cab making sure both sides of cover
roll evenly. For best results leave unrolled portion of
cover attached to the hook and loop fasteners while
opening.
COVER SECURED
OPEN
SAFETY
STRAPS
STEP 9: Secure cover open
by hooking safety
straps to front loops.
STEP 7: Secure hook and loop fastener strips on one side of rail,
by pressing along full length of rail. Pull cover tight across
pickup bed, and secure hook and loop fasteners on
opposite side rail.
NOTE: Secure hook and loop fasteners
along entire length of both side rails before
driving vehicle. This will prevent wind lifting
the cover and causing damage.
HOOK AND LOOP FASTENER
HEADER SEAL
INSIDE TAILGATE