Telematrix SP200 - Manual (Page 11)

11
120V AC Outlet Recovery Power Adapter (provided)
The 120 VOLT AC OUTLET RECOVERY POWER ADAPTER is an featured TeleMatrix
product. It provides both the telephone lines and the power source in one cable
(6P6C line cord) and is designed to recover the use of the power outlet.
Connector Configuration
The 120 Volt Outlet Recovery Power Adapter has two (2) modular jacks. One
jack is labeled “LINE” and the other jack is labeled “PHONE”. These jacks allow
for a fully modular installation.
Power Adapter “LINE” Connection
The power adapter “ LINE” connection i s
used t o connect the te lephone l ine from
the wal l jac k to the po wer adapter .
Using one of the 15-foot modular
telephone line cords, connect one end of
the c ord to the RJ14 t elephone ja ck on
the w all o r b ase b oard. T he remaining
end of the c ord pl ugs into the “ IN” side
of the power adapter.
Power Adapter “PHONE” Connection
The p ower adapter “ PHONE” connection
is us ed to p rovide bo th the te lephone
lines and th
e p ower s ource to the
telephone. U sing on e of t he 1 5-foot
modular te lephone l ine c ords, pl ug o ne
end of the line cord into the ba ck of the
telephone. Plug the r emaining e nd to
the power adapter jack labeled “OUT”.
E H N O P
O UT
Troubleshooting Note: If there is no power to the telephone
after c onnecting the line c ords, c heck to s ee if the line cords
are inserted on the opposite sides of the adapter.
L2 L1 +L 2
N E L _
IN