Brother PE 300S - Manual (Page 67)

64
Contents
Setting Up
Basic Sewing
Machine
Operation
Utility Stitches
Embroidering
Maintenance
Troubleshooting
Error
Messages
Sewing Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory Card)
Removing embroidery unit
1. Remove embroidery hoop. Push “ ” key. Push “ ”
key. The carriage will move to the storage position.
CAUTION
– If the carriage is not in the storage position, you might not
be able to put the cover on the embroidery unit.
– Always make sure to remove the hoop before pushing the
“ ” key button. If you push “ ” key while the small
hoop (sold separately) is still attached, the hoop will hit the
foot and this could result in personal injury.
2. Turn the power off. Pull the embroidery unit to the left, and
remove the unit while pushing the Release button.
CAUTION
Always turn the power off when removing the embroidery unit.
Failure to do so could cause damage.