Brother LE8235001 - Manual

LE8235001
3 If you have Optional Paper Tray,
connect it (otherwise go to Step 4)
1
THANK YOU!
… FOR PURCHASING YOUR BROTHER MACHINE.
WE ARE SURE YOU WILL BE IMPRESSED WITH THE CONVENIENT WAY THAT
YOUR NEW MACHINE PERFORMS SO MANY TASKS WITH GREAT RESULTS!
Follow these simple instructions in numerical order.
For greater detail, consult your Owner’s Manual.
Alternatively, if you cannot solve a problem:
Refer to Frequently Asked Questions (FAQ’s) on Brother Solutions Web Site:
URL: http://solutions.brother.com
Packing List
Keep the packing materials for possible future transport. If you do not pack the machine
properly, it may void your warranty.
Telephone Line Cord
(2 Telephone Line Cords for Australia
and New Zealand Only)
Document Tray
with Extension
Owner’s Manual
Quick Setup Guide
Drum Unit Assembly
(TN-6300)
Document Support
Mains Power Cord
(2 Main Power Cords for Asia Only)
Adapter
(For Australia Only)
External
Telephone Extension
Telephone
TAD TAD
(Example for Australia)
– 1 –
FAX-8360P
Quick Setup Guide
2
4 5 Attach Document
Tray/Support
Install Drum Unit
Load Paper 6
8 7
Install Mains Power
Cord and Telephone
Line Cord
Telephone Answering
Device (TAD),
External/Extension
Telephone Set Your Country
(For Australia/New Zealand Customer Only)
A. Pull the paper cassette
completely out of the machine.
B. Adjust the paper guides at the
right and rear of the paper
cassette for the paper size you
want.
C. Load paper in the paper
cassette. Press down on
the paper to flatten it in all
four corners, keeping the
paper level below the
guide marks.
D. Slide the paper cassette into the
machine until it locks into place.
A. Unpack the drum unit assembly,
and gently rock it from side to side
five or six times to distribute the
toner evenly
inside the
cartridge. C. Open the front cover of the
machine.
To prevent damage to the drum,
do not expose it to light for longer
than a few minutes.
B. Remove the
protective part.
D. Insert the drum unit assembly into
the machine.
You must set your country so that the machine works correctly.
A. Carefully pick up the
machine and place it on
top of the Optional
Paper Tray (Lower
Tray).
Mains Power Cord Telephone Line Cord
Maximum
Paper
Height
Guide
Marks
Document
Support
Document Tray
with Extension
B. Plug the modular cable from the Lower
Tray into the modular socket on the
machine.
C. The optional paper cassette must be used in place of the upper paper cassette. See instructions
supplied with the Optional Paper Tray.
To select which tray will be used for faxes or for copies, see Lower Tray (With Optional Paper
Tray Only).
If you move the machine after connecting the Lower Tray, be sure to carefully lift the Lower
Tray with the machine because they are not fastened together.
E. Close the front cover.
For Australia/New Zealand
You must select the country where you use the machine after installing the
power code.
A. Check that the power is turned on (by plugging
in the power cord).
The LCD shows:
SET COUNTRY
PRESS SET KEY
B. Press Set.
The LCD shows:
AUSTRALIA
SELECT & SET
NEWZEALAND
SELECT & SET
C. Press or to select the country (AUSTRALIA or
NEWZEALAND).
(Be careful you set your country.)
D. Press Set when the LCD shows your country.
E. The LCD prompts you to make sure of the country
again.
AUSTRALIA
1.YES 2.NO
F. Press to go to Step G –OR– Press to go back
to Step A to select the country again.
G. After the LCD shows ACCEPTED for two seconds.
ACCEPTED