Sensaphone SAT4D - Manual (Page 17)

17
Chapter 2: installation
CONFIGURING THE ALARM RECOGNITION TIME
Set the Alarm Recognition Time for each zone input by setting the
DIP Switches according to the table below.
Switch A Switch B
3 seconds Off Off
1 minute Off On
5 minutes On Off
10 minutes On On
TESTING THE SYSTEM
Check that all equipment being monitored is operating normally
and press the Alarm Status pushbutton. All 4 LEDs should light
up green. If an input is in an Alarm condition and has met the
recognition time the LED will light up red. Verify that the LEDs
display correctly under both Normal and Alarm conditions. Make
and hold an alarm to test the alarm delivery process. You must
maintain the alarm condition until all telephone calls have been
received. Once the alarm clears, the dial-out process is cancelled.