Schwank SER(IR) - Manual (Page 11)

GP-MSER-BX-11A
SER / IR Manual
RD: March 2006
RL: 11A
KH
Page 7
FIGURE 5: BOLTING BURNER TO FLANGED TUBE
1 Tube
2 Tube Coupler
3 Swaged section of tube.
4 Point at which the Swaged
tube slides into another section
of tube.
5
Once the two tubes are joined,
place centre of the coupling
over the line of the joint and
tighten.
FIGURE 6: COUPLER KIT
1 Eye Hook
2 Fifth Nut (Holding Inner Burner to
Housing) Do not loosen or Remove.
3 Lock Washers x 4
4 Burner Flange Adapter
5 Nuts x 4 {Nuts could be shipped c/w
lock washers as one piece}.
6 Flanged Section of Heating Tube
• Align the four burner bolts through
the tube flange, secure tightly with
lock washers and nuts
• Note: A Flange Gasket is not re-
quired for this application.
• Secure suspension chain to eye hook
in order to stabilize burner.
1
2
3 4
SER / IR-45 models
SER / IR -60 Models
3
2 1
4
5