Schwank P40U Fenwal - Manual (Page 44)

44
P40U-F / P40U-IF I&O Manual
IM101220
RD: MAY 2014
RL: 5A
Fig.5 Fig. 6
STEP 4: On the second side of the reflector, first Insert a guard pin into the center hole, Fig 5.
Insert remaining guard pins in the reflector holes, Fig 6.
Step 5: Repeat the process with the second guard section.
Fig. 7 Fig. 8
Step 6: Re-install the screws at the bottom edge of the reflector into the three hangers, Fig. 7.
Fig. 9 Fig. 10 (Center) Fig. 11 (End)
Notes:
1) To bend the pins, use needle nose pliers to hold the guard screen securely, Fig.8 and
another set of pliers to bend the pin sideways, Fig.9.
2) DO NOT bend the pins downwards, it can damage the edge of the reflector.
STEP 7: To secure the guard in place bend the end pins of each guard section sideways and
towards each other, Fig. 10 & 11. The center pin does not require bending.
Hold guard screen
firmly to bend pins