Schroth Racing All models - Hardware Guide - Manual (Page 6)

Part Number LV7
Locations Shoulder
Webbing 3”
Approvals FIA, SFI 16.1
Wrap Type Standard 3-Bar Slide
The standard 3 bar slide for use with B24.15.33 and B23C on 3” webbing.
Most commonly used to wrap 3” shoulder belts around a bar of the roll
cage. Uses the standard wrapping technique.
Part Number LV17
Locations Shoulder
Webbing 3”
Approvals FIA, SFI 16.1
Wrap Type Non Micro-slip 2-Bar Slide
Lightweight 2 bar slide for use with 3” webbing being wrapped around a
bar of the roll cage. Uses unique Non Micro-slip wrap.
EXTRA HARDWARE
Eyebolts
Part Number Bolt Size Thread Length
SG 22 7/16” 22mm
SG 23 7/16” 38mm
SG 35 M10 25mm
Bolts
Part Number Bolt Size Thread Length
SG 10 7/16” 25mm
SG 29 7/16” 38mm
SG 33 M10 25mm
SG 57 M8 25mm
Offered in lengths shown. Designed to be used with Schroth B14 Snap-in
brackets.
Offered in lengths shown, Grade 8.8
Backing Plates
Part Number Bolt Size
SG 39 7/16”
SG 55 M10
SG 54 M8
Essential for any application where you are drilling through a fl oor and
creating mounting points. Available with bolt sizes shown.
Bolt Reducing Collars & Washers
Hole Size Sleeve Part # Washer Part #
7/16” S65 S82
3/8” S64 S83
5/16” S85 S86
Schroth offers high quality machined bolt size
reducing sleeves that fi t into all 13mm (1/2”) bolt
holes. These apply for B24, B63, and B45 brack-
ets. On the B63 and B45 brackets, they allow the
bracket to swivel to follow the correct webbing
path. When used with a B24, due to the 5mm
bracket thickness, they are only a size reducer.
Shown with SG29 38mm bolt. FIA, SFI 16.1 and SFI 16.5 approved (when
used with SFI 16.5 approved bracket).