S&S Cycle Lloydz Motorworkz Billet Air Cleaner Kit for Victory Motorcycles - Manual (Page 7)

7 – Now that the air box is removed, clean up all of the plastic shavings on and around the motorcycle with the plastic sheeting in place so no
debris enters the intake.
Always wear eye protection when removing and cleaning plastic shavings from the work area to avoid injury to the eyes.
Note: Clean rags work well for removing debris from the frame rails and then follow up with compressed air. Once the motorcycle is free of debris, sweep
the floor so you have a clean work area before moving on to the next step.
InstALLAtIon
Installing the Lloyd’z Motorworkz Air Cleaner Assembly
1 – Locate the backplate, top cover plate, throttle body gasket, M6 fasteners, 243 Blue Loctite®, and filter element in the air cleaner kit as illustrated
in picture 18 below.
2 – Remove the tape from the frame rails as well as the plastic sheeting covering the throttle body.
3 – Place the throttle body back on top of the rubber intake manifold making certain the O-ring is still in the rubber intake manifold.
4 – With the throttle body in position, place the supplied gasket on top of the throttle body.
Note: The throttle body gasket is designed to be installed dry. Do not use any type of sealer.
5 – Locate the four socket head cap screws that were removed from the throttle body and stock air box at disassembly. Clean the threads and
apply 243 Blue Loctite® on them.
6 – Locate the backplate and place it on top of the throttle body making certain the throttle body gasket is captured between the throttle body
and the backplate.
Wire Saw
picture 16
Wire Saw
picture 17
WARnInG
7
1- Backplate
2- Filter Element
3- M6 Fasteners
4- Throttle Body Gasket
5- 243 Loctite®
6- Top Cover Plate
picture 18