S&S Cycle Lloydz Motorworkz Billet Air Cleaner Kit for Victory Motorcycles - Manual (Page 4)

throttle Body Removal
1 – Remove the throttle cables from the throttle body following your Victory® service manual for the specific model you’re performing the work on.
2 – Remove the four socket head cap screws from the throttle body. picture 7 and picture 8 below point out the socket head cap screws that need
to be removed.
Note: The four socket head cap screws that are removed will be used for attaching the new Air Cleaner.
3 – Remove the throttle body from the motorcycle by sliding it out from the right side (throttle cable side).
4 – With the throttle body removed, slide a large piece of clean plastic between the air box and the rubber intake manifold as illustrated in picture 9
below. This will help keep any debris from entering into the motor.
Note: Covering the intake manifold must be done before you move on.
picture 9
picture 7
Socket Head Cap Screws
Socket Head Cap Screws
picture 8
4