S&S Cycle Lloydz Motorworkz Billet Air Cleaner Kit for Victory Motorcycles - Manual (Page 10)

Note: There are three dual wire spring clamps included in the kit. The two smaller diameter clamps go on the pre-formed breather hose. Push the 90° end
of the breather hose over the brass barb in the air cleaner backplate followed by the dual wire spring clamp as illustrated in Picture 24 below.
4 – Route the straight end of the breather hose between the air cleaner and the frame rail and over the top of the rear rocker cover.
5 – Locate the supplied straight union breather fitting.
Note: The barbed ends of the straight union fitting have two different outside diameters. The small diameter end goes in the pre-formed breather hose
and the large diameter goes into the stock breather hose.
5 – Push the small outside diameter of the straight union fitting into the formed breather hose followed by the dual wire spring clamp.
6 – Remove the cover from the stock breather hose that was put in place during the stock air box removal. Slide the large dual wire spring clamp
over the stock breather hose.
7 – Push the stock breather hose over the straight union fitting followed by the dual wire spring clamp.
8 – Rotate dual wire spring clamps so they are not contacting the frame rail.
Note: A small piece of black electrical tape should be applied to the frame rail where the breather fitting and dual wire spring clamps are close to
contacting the frame. This will reduce the risk of scratches to the frame.
9 – Secure the stock breather hose to the frame using the supplied 8” black wire tie. picture 25 below illustrates the proper breather hose routing,
black electrical tape location and secured breather hose to the frame.
10 – Install fuel line and connect to its original location from where it was removed.
Key switch Cover and Coil Mounting Bracket Installation
1 – Connect the coil and the ignition switch to the primary wiring harness at the connectors. Install the coil mounting bracket back to its original
location, to the front and rear heads, using the socket head cap screws that were removed at disassembly. Tighten fasteners 85 inch pounds.
2 – Connect the spark plug wires back to the coil. picture 26 next page illustrates the proper location of the spark plug wires. Front cylinder plug
wire connects to the bottom post on the coil and the rear cylinder plug wire connects to the top post on the coil.
picture 24
Black Electrical Tape
Secured Breather Hose
picture 25
10