S&S Cycle Lloydz Motorworkz Billet Air Cleaner Kit for Victory Motorcycles - Manual (Page 2)

DIsAsseMBLY
seat and Gas tank Removal
1 – Disconnect the negative battery cable from the motorcycle and route it away from any metal parts in the area.
2 – Remove the seat and gas tank from the Victory® motorcycle following your Victory service manual for the specific model you are performing
the work on.
Key switch Cover and Coil Mounting Bracket Removal
1 – Remove the ignition key switch cover by pulling outward on it. picture 2 below illustrates the key switch cover.
2 – Remove the four socket head cap screws from the ignition and coil mounting bracket that holds the bracket to the front and rear heads.
picture 3 below points out the location of the four socket head cap screws.
3 – With the bracket free from the front and rear head unplug the spark plug wires at the coil.
4 – Disconnect the coil and ignition switch at the connectors freeing them from the primary wiring harness.
Idle Air Control Hoses and throttle position sensor Removal
1 – Disconnect the Throttle Position Sensor (TPS) at the connector leaving the TPS attached to the throttle body. picture 4 next page points out
the TPS connector.
2 – Remove the Idle Air Control (IAC) supply hose from the air box.
Note: Leave the 1.500” rubber hose attached to the hard plastic IAC supply hose. Picture 4 points out the IAC air supply hose and the 1.500” rubber hose.
3 – Remove the front Idle Air Control (IAC) air delivery hose from the rubber 90° fitting that leads into the front intake bore on the throttle body.
Leave the 90° rubber fitting attached to the throttle body. picture 4 points out the IAC front delivery hose.
4 – Remove the rear IAC air delivery hose from the rubber “T” fitting that leads into the rear intake bore on the throttle body. Leave the rubber “T”
fitting attached to the throttle body. picture 4 points out the IAC rear delivery hose.
picture 2
Key Switch Cover
picture 3
Socket Head Cap Screws
2