S&S Cycle 49-State Certified X-Wedge Engines - Manual (Page 9)

9
14- Use a pair of pliers to firmly press the metal connector into place over both wires. See Picture 12. NOTE: You can put a small amount of pressure
on the connector as you position the wires to make sure they are in the correct position. Once the connector is pressed in, close the blue plastic cover
and listen for a click to confirm it is seated.
15- Insert the white wire with the orange stripe into position #8. Next insert the white wire with the blue stripe into position #23. See Picture 13.
16- Confirm that there are two 15-amp fuses in the blue tap-a-fuse on the red wire. Then insert it into the fuel pump fuse slot. See Picture15. Take
care not to disconnect the fuses as you slide it back into the fuse holder. See Picture 16.
Picture 12
Picture 13
Picture 15 Picture 16