Retsch PP 25 User Manual
Page 20
Operating the machine
20
Avoid, extending the cylinder to its maximum height while the pressure is
building up.
•
Turn the threaded spindle (D) upwards.
•
Put the die tool (PW) on the pressure cylinder (J).
•
Turn the threaded spindle downwards until it rests on the die tool.
•
Close the valve (H) by turning in a clockwise direction.
•
Build up the required pressure force (t) by moving the hand lever (B)
forwards and backwards.
5.5.4
Removing the Die Tool and Tablet (1)
NOTE
A quick drop in pressure can cause the pellets to break.
•
Open the shut-off valve (H) very slowly by turning in an anti-clockwise
direction.
Fig. 5: After the Pressing Procedure
•
Pull the slide (S) out of the die tool.
Fig. 6: Ejecting the pellet
•
Close the valve (H) by turning in a clockwise direction.
S
PR
- BB 50 (41 pages)
- BB 100 (24 pages)
- BB 200 (24 pages)
- BB 300 (24 pages)
- Cryomill (68 pages)
- CryoMill Autofill 50l (28 pages)
- DM 200 (20 pages)
- DM 400 (60 pages)
- Emax (67 pages)
- GM 200 (44 pages)
- GM 300 (44 pages)
- MM 200 (32 pages)
- MM 400 (32 pages)
- PM 100 (44 pages)
- PM 400 (36 pages)
- PM GrindControl (48 pages)
- RM 200 (36 pages)
- RS 200 (32 pages)
- SK 100 (24 pages)
- SM 100 (48 pages)
- SM 200 (48 pages)
- SM 300 (44 pages)
- Cyclone - SM 300 (20 pages)
- SR 200 (24 pages)
- SR 300 (24 pages)
- TWISTER (44 pages)
- ZM 200 (32 pages)
- AS 200 jet - Automatic Vacuum Regulation (6 pages)
- AS 200 control - natural frequency (32 pages)
- AS 200 (36 pages)
- AS 200 jet (56 pages)
- AS 200 jet (48 pages)
- AS 200 tap 30.025.0001 (28 pages)
- AS 200 tap 30.025.1001 (28 pages)
- AS 300 (32 pages)
- AS 400 (32 pages)
- AS 400 (28 pages)
- AS 450 basic (40 pages)
- AS 450 basic (44 pages)
- AS 450 control (52 pages)
- DR 100 (40 pages)
- DR 100 (28 pages)
- PP 40 (28 pages)
- PT 100 (36 pages)