Retsch RS 200 - Manual (Page 12)

15.11.2006

Retsch GmbH
12
Doc. Nr. D 98.725.9998
Electrical connection

Voltage and frequency for the RS200 are given on the
type plate.

Ensure that these values correspond to the available
power supply system.

Connect the RS200 to the power supply system using
the supplied connection cable.

Protection by external fusing is to be carried out when
connecting the mains cable to the power supply,
according to the regulations at the place of installation.
If the values on the type plate are not observed this can
cause damage to the electronic and mechanical
components.
Electrical connection should be carried out only by a
qualified electrician. Danger through current surge.
P
G
Fig. 4 Removing the transport safety device
device
Abb.1 Betriebsarten