Precisionsound Multimonica II - Manual (Page 9)

9
© Copyright Precisionsound 2014 www.precisionsound.net
Multimonica II Accordion for NI Kontakt 3,4 & 5
Multimonica Page
On the front page of the Accordion GUI, named “Multimonica”, you can select a reed organ register, and
adjust dynamics and modulation. From left to right, the controls are:
Sound
Preset Menu: sets the currently active Multimonica II reed organ preset for played notes. Five register
presets are available. In addition to being selectable with this menu, presets can be chosen by pressing
keyswitches on your MIDI keyboard. The keyswitch for each preset is shown on the menu. They are as
follows:
Preset Keyswitch note
Preset 1 C1
Preset 2 C#1
Preset 3 D1
Preset 4 D#1
Preset 5 E1
The playable range for all presets is F1 – C6.
Tone: models the change in sound that occurs as more air is pushed through the Multimonica’s organ
reeds. The tonal change increases as the dial is turned right.
CC1 Tone +/-: switches the effect of the modulation wheel (CC1) on your MIDI controller between
increasing and decreasing the simulated airflow.
 The effect of the modulation wheel is offset from the current value of the Tone dial. Therefore,
CC1 Tone + takes effect only if Tone is less than 100%, and CC1 Tone - takes effect only if Tone is
more than 0%.