Pavement Ends 41826 Cargo Cover - Manual (Page 4)

41826 pg 4 0509 Rev. A
The Fabric Protector
sewn into the fabric
must be located over the Tail-
gate Retainer Mounts.
Step Seven
S ECURE R EAR C ORNERS
Roll the plastic strips, sewn into the
rear corners of the Cargo Cover into
the Corner Retainers. Slide the cor-
ner plastic strip toward the front of
the vehicle and make sure that the
plastic strip fi ts up into the retainer
so that the collar fi ts properly.
Plastic Strips
Fabric
Rear Corner
Retainer
Detail of Plastic Strip
Plastic
Strip
Detail of Fabric
Protector
Make sure the Fabric Protector
under the fabric covers the end of
Tailgate Mount
Hook and
Loop Strips
Step Eight
S ECURE C OLLARS
Tuck the seat belt assemblies into the rear sport bar
collars and close the rear sport bar collars by pulling
fi rmly on the fabric and fastening the Hook and Loop
Strips to each other.
Tighten the straps on the front of the Cargo Cover.
Pull gently down, then out
to release plastic strip
To Remove Cargo Cover
When removing the Cargo Cover, use
the loops sewn to the fabric to release
the plastic strips. Pull gently down, then
straight out to release the plastic strip
from the retainers.