Pavement Ends 41423 Cab Curtain - Manual (Page 2)

41423 pg 2 0907 Rev. A
Phillips Screwdriver
Power Drill
1/8" Drill Bit
Pencil Center Punch or
Utility Knife
Silicone Sealant
Safety Glasses
Tools Needed
Parts List and Hardware Identifi cation
#8 x 1" Pan Head Screw, Part
Number 295.95, Qty - 5,
Cab Curtain Fabric Qty - 1
“Z” Channel, 29 1/2" Qty - 1
Snap Head Screw, Part
Number 200.49, Qty - 3, Acorn Locknut, Part
Number 427.11, Qty - 3,
Step One
I NSTALL “Z” C HANNEL
Fold the front seats forward and locate the
“Z” Channel in the parts kit. Orient the chan-
nel so that, when installed, the opening will
be down. Place the channel on the vertical
face of the riser between the front and rear
fl oors, centered in the fl at area in the middle
of the vehicle. The top edge of the channel
should be fl ush with the top of the riser. Use
the holes in the channel as guides to mark,
center punch and drill fi ve 1/8" holes. Install
the channel using the fi ve #8 x 1" Pan Head
Screws from the parts kit.
Check for wiring and fuel lines before drilling holes in riser.
It is easier to drill holes by either slitting the carpet with a 1/2" “X” shape to access the sheet metal, or center punch
through the carpet, remove the carpet and drill the necessary holes - then add smaller slits in the carpet to access the
holes for attachment.
After drilling the holes for the “Z” Channel in the fl oor riser, put silicone sealer on the holes before installing the channel
with the screws.
If the vehicle is equipped with a factory console, it will be necessary to leave the center screw out of the channel.
“Z” Channel
Riser
Rear Floor
#8 x 1" Pan
Head Screw
Rear
Floor
Riser Front
Floor
Rear Floor
29 1/2" “Z”
Channel
Riser
Front
Floor
Threading Strap
through Buckle
Buckle
Strap
Step Two
F ASTEN S TRAPS
Orient the Cab Curtain with the window
toward the top and with the vinyl side
out, toward the rear of the vehicle. Start
with the top straps and wrap the four top
straps around the sport bar. Then thread
the end of each strap through each
buckle. Loosely tighten each strap to
hold the Cab Curtain in position. Repeat
this procedure with the side straps. It
may be necessary to lift up slightly on
the Fold Down Bow to work the middle
strap underneath, in order to wrap it
around the sport bar.
Cab Curtain
Sport Bars
Top Straps - Wrap
around Sport Bar
Rear Sport
Bar
Fold Down Bow - Work
Strap under Bow