Pavement Ends 41422 Cab Curtain - Manual (Page 4)

41422 pg 4 Rev. B 0303
Step Three - Optional
At the marked locations, push the sharp end of a Snap Head
Screw through the Cargo Cover from the backing side, to
make a hole. Once a hole is formed, pull the screw back out
of the hole. Then push the screw through the hole from the
vinyl side so that the snap is on top of the vinyl. Thread an
Acorn Locknut over the pointed end of the Snap Head
Screw. Snap the Cargo Cover and Cab Curtain together with
the three snaps.
Fabric - Backing Up
Fabric Reinforcement
Fabric - Vinyl Up
If You Have a New Cargo Cover on Your Vehicle*
Cargo Cover
Step Two - Optional
Pull up on the front, reinforced edge of the Cargo Cover
and mark the locations matching the three snaps on the
Cab Curtain flap, on the webbing along the top of the
Cargo Cover.
Cab Curtain - From Rear
Pull Flap out and
over Cargo Cover
Push Snap Head Screw
through to form a hole
Install Studs on Fabric Reinforced
Front Edge
Snaps - on underside of flap
Snap Head Screw
Acorn Locknut
* If you do not have a Cargo Cover, save the three
(3) snaps and nuts for possible future use.
Step One
Locate the flap sewn to the rear of the Cab
Curtain. Pull the flap out over the top of the
front edge of the Cargo Cover.
Note: There are two sets of snaps
located on the Cab Curtain flap.
-If you have a YJ use the upper snaps.
-If you have a TJ use the lower snaps.